Lesson #14: Angles in Standard Position (Coterminal Angles, Principle
Angles and Reference Angles)
Learning Target
T1.4: I can sketch an angle, measured in degrees or radians, in standard position (clockwise and
counterclockwise rotations).
T1.5: I can determine the principal angle for a set of coterminal angles measured in degrees or radians.
T1.6: I can determine the measures, in degrees or radians, of all angles in a given domain that are coterminal
with a given angle in standard position.
T1.7: I can write the general form of the measures, in degrees or radians, of all of the angles that are
coterminal with a given angle in standard position.
counterclockwise rotations).
T1.5: I can determine the principal angle for a set of coterminal angles measured in degrees or radians.
T1.6: I can determine the measures, in degrees or radians, of all angles in a given domain that are coterminal
with a given angle in standard position.
T1.7: I can write the general form of the measures, in degrees or radians, of all of the angles that are
coterminal with a given angle in standard position.
Notes
angles_in_standard_position_and_special_angles.pdf | |
File Size: | 228 kb |
File Type: |
Videos
Textbook (Notes and Examples)
Page 170 - 172 Coterminal Angles
Practice Questions
Textbook: pg. 175 Question 6 Angles in Standard Position
pg. 176 Questions 7, 8, 9, 11 a, b, d, e, g, h Coterminal Angles
pg. 176 Questions 7, 8, 9, 11 a, b, d, e, g, h Coterminal Angles
Formative Assessment
fa_23_-_angles_in_standard_positon_and_special_angles.pdf | |
File Size: | 175 kb |
File Type: |